Location        Home        Products        High-Solids Epoxy Floor Intermediate Coat

High-Solids Epoxy Floor Intermediate Coat

Name: Kingcoat FIC-630HS
Introduction:

     A two-component, ambient temperature cure, high-solids epoxy intermediate coat which is based on the primer resin (Kingcoat FP-210HS), and made by adding an appropriate amount of pigments and fillers. This system is applied for coating on cementitious substrates. When it cures, it forms a tough and hard finish with good adhesion between both primer and topcoat, and enhances overall properties of the concrete floor, including abrasion and impact resistances. The coat is resistance to many mild chemicals, oil and water, also protects the surfaces by preventing algal & fungal growth. The coat is a good performance/price ratio material.

Mixing Ratio: A-component/B-component=7/1(weight)
Package: A-component=21kg, B-component=3kg
       Information

Application Advantages
?Eco-friendly, more than 90% solid contents, low VOC composition
?High filler contents, low cost
?Resistance to mild chemicals, oil and water
?Good toughness, high hardness
?Provides good adhesion between both primer and topcoat
?Increases overall properties of the concrete floor, including abrasion and impact resistances
?Can be applied on fresh, old concrete surface
Application Procedure
   While applying Kingcoat FIC-630HS coat, surface preparation is the most important part. Remove all the loose materials to expose the base surface. Wash the surface with plenty of water. A 10% muriatic acid solution wash should follow. Againwash the surface with plenty of water. Let the surface dry to saturated surface dry (SSD) condition. Fill all the cracks, honey-combs, voids etc, using cement mortar or our Kingbond repair compound. Let the surface dry completely and polish it with grinding leveling. Apply a coat of Kingcoat FP-210HS liberally by brush or roller over the surface. Allow the surface to be touch-dry. Mix the A and B parts of Kingcoat FIC-630HS thoroughly, to get a uniform consistency. Trowel the first coat over this primer coat. Allow the coat to cure for 12 hours. Again trowel the second coat over the first coat, preferably in a perpendicular direction to the first coat, and so on until the coating thickness. Let the system cure for 24 hours. Protect the treatment during the curing period from mechanical disturbances, water splashes, direct sunlight & heat.
Application Areas
? Industrial manufacturing facilities, warehouses, airports
? Chemical and pharmaceutical plants
? Outdoor stadium, court and swimming pool
? Workshops, laboratories, garages
? Outdoor/indoor wall, road, bridge
? Easy to maintenance, low-cost floors